E-mail: sale@jjsgr.com
Contact Us

TEL: +86-134 3556 4100
E-mail: sale@jjsgr.com
Address: Fengxi Industrial Zone, Chaozhou, Guangdong, China

Home > News > Content
Wash Basin Bathroom Sink Installation Instruction
Jan 10, 2018

Wash art basin Installation Instruction

 

Preparation before installation

 

Check products and tools.

 

Products and fittings:

 

Basin,tap set, water supply pipe ,outlet waste, bottle trap

 

Tools and material:

 

hammer drill, silicone, spanner, sealing tape, pencil, water pump plier, oil stone,Pedestal brackets,screwdriver,extension wire, ruler, scissor.

 

Installation

 

1.Cut hole

To drill a hole of 75mm on the top of the table for the waste as drawing1.

 

2.Fix waste

 

To fix waste as drawing2. 3.Silicone

 

Apply silicone to the bottom of the basin as drawing3. 4.Position basin

 

Position the waste through the precut hole and locate the basin on the table top. Ensuring good surface contact.

 

5.Remove silicone.fig5

 

Remove any excess silicone at the edge of the basin. 6.Allow some time for the sealant to cure before proceeding

 

with water and waste connections.

 

Care & maintenance

 

1.To preserve its polished surface, this product should be cleaned with a soft cloth using warm soapy water or household detergent. Do not use abrasive-based compound as these will scratch the surface.

 

2.If accidental scraches,abrasions or burns occur, the surface finsh can be restored by gentle polishing with a polish recommended by the maufacturer.

 

Installation Instruction

 

Preparation before installation

 

Check products and tools. Products and fittings:

 

Basin ,tap set ,water supply pipe, outlet waste, bottle trap

 

Tools and Material:

 

Hammer drill, silicone, spanner, sealing tape, pencil, water pump plier, oil stone, pedestac brackets, screwdriver, extension wire, ruler, scissor.

 

Installation:

 

1.Remove basin from carton and check for damage. 2.Establish the center of the basin and mounting height. 3.Draw a horizontal line on the wall and mark the position of

 

the fixing holes. Suitablefor the chosen fixing system. 4.Drill fixing holes for the fixing system selected appropriate

 

to the construction of the wall. 5.Fix the bracket to the wall.

 

6.Fit the chosen tapset to the basin (do not over tighten as this may damage the basin).

 

7.Fit the waste to the basin using a waterproof mastic between the top of the waste and the basin.(do not over tighten the back nut as this may damage the basin)

 

8.Fit the basin to the chosen fixing system and ensure the basin is level side to side

 

9.Fill any gap between the basin and the wall with an appropriate filler.

 

10.Connect water supply and waste connection and check for leaks.

 

Care &maintenance

 

1.To preserve its polished surface, this product should be cleaned with a soft cloth using warm soapy water or household detergent. Do not use abrasive-based compound as these will scratch

 

the surface.

 

2.If accidental scratches, abrasions or burns occur, the surface finish can be restored by

 

gentle bolishing with a polish recommended by the manufacturer.


QQ截图20180110141932.jpg

Copyright © Jiajueshi Group Limited All Rights Reserved .